Quantcast

configuration

  1. cjlhessing

    Question Yamaha YPAO R.S.C help

    Any help appreciated here :) So I'm going to try re-running YPAO this week because I have finally managed to get things set right with my rear speakers (placing onto stands behind sofa, coming down from ceiling level) and have learnt over the past day or so a lot about what some of the terms...
  2. C

    9 speakers configuration - 5.2.4 or 7.2.2?

    Hello everyone, Having recently acquired a Denon X4500H, I'm ready to dip in to object-based audio :) I'd appreciate some opinions on how to configure 9 speakers: 5.2.4 vs 7.2.2. I have 6 Tannoy Mercury VR speakers, complementing Mercury V floorstanders, a Mercury VC and 2 SVS subs. Before...
  3. LovingLife69

    Question Help Dolby Atmos config with Amazon Prime and Plex !!

    HI all, Hope you are all well.. I've just added speakers to my system to enable Dolby ATMOS and I use an Apple 4K box and Nvidia TV (2017) with ARCAM 550 + Power Amp. I understand I can get programs in ATMOS from Netflix (Netflix UHD subscription, Using Apple 4K) and Amazon Prime (Nvidia...
  4. I

    Yamaha Configuration Advice.

    I currently Have the following. Yamaha RX-V685 AV Receiver Yamaha AS201 Stereo Amp Just a little unsure if I could connect these together? At the moment everything runs through the AV including the Turntable but I suppose what I want to do is utilise the equipment & speakers I have to get the...
  5. K

    panasonic GZ series Speaker configuration

    Hello I am new to the forum. I am trying to find information on the different speaker configurations for Panasonic TX-GZ-2000B, TX-GZ-1500B TX-GZ-1000B and TX-GZ-950B TVs. I know that the 2000 has upward facing speakers. And the 1500 was a two speaker forward facing blade. But I am not sure...
  6. P

    Yamaha WXA50 speaker wiring

    Hi All, I need to connect a pair of speakers with a 3 wire cable but can’t tell which terminal is common. Does anyone have any tips or guidance. Have looked at the amplifier wiring diagram but not clear which is common. Any help would be much appreciated. I’m new to the forum so please forgive...
  7. ESGSanders

    New LG C8 has Dolby Atmos - Home Cinema configuration

    Hi all, Just bought a lovely new LG C8. It has Dolby Atmos. I already have a full home cinema setup (5.1 dolby pro logic iix (no subwoofer)) but the amp doesn't have Atmos inbuilt. Wondering whether I should connect the sound to the TV and then out to the Amp in order to make the most of the...
  8. T

    Question Configuration help please.

    I have audiolab 8200cd 8200a 8200p. Online i have seen it suggested that to avoid the 8200a weaker pre-amp,you can do the following. Change CD to varible output with remote,and then out to 8000p and then out to 8200a and set that to Pre-power av. My question is,has anyone tried this.What does it...
  9. 9Cows

    Denon AVR-X2300W Configuration Issues Stereo

    Hey guys, A little lost with a small (or perhaps a very large) configuration issue with my Denon AVR-X2300W, it is hooked to a 55Inch TV, Wharfedale 8.4s for fronts, a Yamaha (90s) Center, and Wharfedale Diamond 9.0s for the rear, a focal 10 inch subwoofer and a gaming/media PC to run it all...
  10. SuperCow

    Switch between 5.1.4 and 7.1?

    Hi guys I have a Denon AVXR 4400H and can therefore support up to 10 channels. However I can get 12 speakers cabled in the room in the usual locations (Subwoofer, 2 front, 1 center, 2 surrounds, 2 surround backs and 4 overhead). I know about the possibility to pre-amp to get a full 7.1.4...
Top Bottom