senzaparole
Established Member
Hello, I own the Denon in question.
I would like to connect a headphone amplifier to my AVR.
I tried to connect the DENON "zone 2" output with an analog RCA cable (white and red RCA) but in no way was I able to send the audio to the headphone amplifier.
Where am I wrong?
I could also use the "pre out" outputs of the Denon, however I would like the volume output from the Denon to have no control because I would like to control the volume directly on the headphone amplifier.
So I would like the volume of audio output from the Denon to be at maximum volume, assigning the task of adjusting it to the headphone amplifier.
I try to solve the problem of the lack of audio I found by connecting the headphone amplifier to the "zone 2" or I connect the latter to the "pre out" output of the Denon, which should give less problems than the "zone 2" ?
I would like to connect a headphone amplifier to my AVR.
I tried to connect the DENON "zone 2" output with an analog RCA cable (white and red RCA) but in no way was I able to send the audio to the headphone amplifier.
Where am I wrong?
I could also use the "pre out" outputs of the Denon, however I would like the volume output from the Denon to have no control because I would like to control the volume directly on the headphone amplifier.
So I would like the volume of audio output from the Denon to be at maximum volume, assigning the task of adjusting it to the headphone amplifier.
I try to solve the problem of the lack of audio I found by connecting the headphone amplifier to the "zone 2" or I connect the latter to the "pre out" output of the Denon, which should give less problems than the "zone 2" ?